Service Manual

b. Hold the flywheel with a spanner wrench or

strap wrench and torque the nut to 150-160

in•lb (16.9-18 N•m).

Install Ignition Module

1. Install the ignition module, the stop switch wire

or ground lead tab terminal (if so equipped),

and module fastening screws

2. Move the ignition module away from the

flywheel as far as possible. Tighten the

fastening screws slightly.

3. Insert a 0.010-0.015 in. (0.254-0.381 mm) feeler

gauge or shim stock between the

ignition module and flywheel magnet

surfaces.

NOTE: Brass or plastic feeler gage or shim stock

is more suitable for this application because of the

magnetic forces.

4. Loosen the module fastening screws and push

the ignition module tight against the feeler

gauge or shim stock.

INSTALL MAJOR COMPONENTS

(cont.)

2.6089.116

2.6089.117

2.6089.083

Optional

Stop Switch

Flat Feeler

Gauge

REASSEMBLY

4-11