Service Manual

3. Install the shroud extension/engine stand

around the cylinder. Make sure the tabs in the

shroud extension/engine stand are

inserted in the slots in the fan shroud. Make

sure the spark plug wire and ignition switch

leads are properly routed out of the starter

housing.

4. Install the fastening screw through the starter

housing and into the shroud extension/

engine stand.

Torque the screw to 25-35 in•lb (2.8-3.9 N•m).

Blowers And Blower/Vacs—Models 280, 300BV,

310, And 310BV

1. Connect the push-to-stop switch leads to the

ignition module.

2. Install the starter housing to the fan shroud and

secure with four screws.

Torque the screws to 35-40 in•lb (3.9-4.5 N•m).

NOTE: It may be necessary to pull the starter

rope slightly to enable the starter housing to drop

into position.

3. Install the shroud extension around the

cylinder. Make sure the tabs in the shroud ex-

tension are inserted in the slots in the fan

shroud. Make sure the spark plug wire and

stop switch leads are properly routed out of

the starter housing.

INSTALL MAJOR COMPONENTS

(cont.)

2.6089.063

2.6089.067

2.6089.068

REASSEMBLY

4-13