Service Manual

Ignition Switch Replacement
Some models are equipped with an ignition switch
installed in the starter housing or styling cover. Sev-
eral types of switches have been used. Service the
switches as follows:
Toggle Switch
1. Disconnect the lead wires from switch.
2. Remove the nut, switch plate and switch body.
3. Reassemble the switch in the reverse order of
disassembly.
Torque the nut to 25-35 in•lb (2.8-3.9 N•m).
Slide Switch
1. Remove the screw, lead wire, contact plate,
and switch cover.
2. Remove the screw and slide contact.
3. Reassemble the switch in the reverse order of
disassembly.
Torq ue the screw securing the slide contact to
starter housing to 10-15 in•lb (1.1-1.7 N•m).
Torque the screw securing the lead wire and
contact plate to switch cover to 7-12 in•lb (0.8-
1.4 N•m).
DISASSEMBLE MAJOR
COMPONENTS (cont.)
2.6089.070
3.6090.134
3.6089.069
3
DISASSEMBLY, INSPECTION, & REPAIR
3-33