FORM NO. 3314-468 Rov. B MODEL NO. 59174 INSTALLATION MODEL NO. 59179 INSTRUCTIONS RECYCLER® MOWER BAGGING KIT Since this instruction sheet covers only a minimal amount of information necessary to maintain and i A important operate your mower, we suggest that you keep this material with your Operator’'s Manual so that both Your Recycler® mower has been updated to may be referred 1o for instructions concerning safe permit bagging. Make sure that your dearer operation and proper maintenance procedures.
ASSEMBLY INSTRUCTIONS INSTALL DISCHARGE TUNNEL Note: Determine left and right sides of mower by standing behind handles, 1. Remove spark plug wire from spark plug. 2. Remove and save the (4) bolts securing the Recycler® mower cover and deflector assembly to the deck (Fig. 1). Save the assembly for possible future re installation. BOLTS [‘ 4 DEFLECTOR ASSEMBLY Figure 1 3. Position discharge tunnel and door assembly on deck. Align holes in discharge tunnel with holes in deck {Fig. 2.
ASSEMBLY INSTRUCTIONS A\ WARNING # Be sure that spring does not contact gas tank or any other part of engine. * Wear between spring and engine parks may result in an unsafe operating condition. * if spring contacts any part of engine, do not install beggar kit on mower. If you need assistance contact an Authorized Toto Service Dealer before proceeding. DECAL LOCATION INSTALL BAGGING DECAL 1. Thoroughly clean flat area of mower deck behind discharge tunnel with a soap and water solution.
OPERATING INSTRUCTIONS 5. EMPTYING engine and wait for all moving parts to stop. Lift discharge door handle straight up and move it forward to engage the locking pin with catch {Fig. 6). Grasp bag frame handle and rear of grass bag and lift bag off mower, Gradually tip bag forward to empty clippings. 6. To reinstall bag, repeat steps 2—4. ® Grass clippings and other objects can be thrown from an open discharge tunnel.
OPERATING INSTRUCTIONS CHECK BLADE BRAKE CLUTCH SYSTEM 1f your mower has a BEC (Blade Brake Clutch) safety system, the grass bag can be used to check for BBC system deterioration. {For an additional BBC test, refer to "Check Control Bar® section in your operator's manual.) 1. Install the empty grass bag on the discharge tunnel. 2. Push the control bar down 1o the lowest position {Fig. 10). 3. Lift the control bar to the normal “blade engaged position, about 2" below the handle.