FORM NO. 3313-792 \ MODEL NO. 59176 INSTALLATION MODEL NO. 59178 INSTRUCTIONS L EASY-EMPTY GRASS CATCHER For HMR 1200 and Rear Engine Riders J SET UP INSTRUCTIONS Install Mounting Brackets to HMR 1200 Note: Mounting brackets are not required when amounting grass catcher on a rear engine rider. 1. Secure {2} mounting brackets and brace to rear of HMA frame with (8} cap screws (7/8" Ig.) and knockouts as shown in fig. 1. ) fissile ! RACKETS I e Figure 1 Install Hitch Bracket 1.
SET UP INSTRUCTIONS Note: Try to open basket door when handle is pushed in completely, if basket opens, dump handle is not pushed in far enough or basket is not closed tightly. 4, Position hitch bracket spacer into hole in hitch . Rotate grass basket up 8o mounting pins line up with mounting holes in brackets on the HMR 1200 or the stand bars on rear engine riders. Push pins through holes and retain with hair pin cotters. Assemble and Install Chute Assembly and Duct 1.
OPERATING INSTRUCTIONS A final condition to consider is ground speed. As the engine overloads (slows down} air velocity decreases. Therefore, ground speed of the rider must be slow enough to allow all grass clippings to move continuously from under the housing, through the duct, and into the grass basket, . Y grass deflector or entire grass catcher in place. Bagging Tips 1. To assure maximum air currents in the system, nova throttle to FAST and gear shift to a slow ground speed. 2.