Installation and User's Guide

START TIMES Setup

The START TIMES setup will instruct the controller the time to activate the selected program

during an active watering day. Lawn Master II provides three start times per program to

accommodate all your irrigation needs.

Step 1 – Place the function dial to the START TIMES position.

Step 2 – Press

PRG

to select the program being modiﬁed. Select from A, B or C.

Step 3 – Press or to select the START TIME number (1, 2 or 3) being modiﬁed.

Step 4 – Press or to adjust the time to the desired START TIME. For unused start

times, make sure OFF is displayed. OFF is located between 11:45pm and 12:00am.

Each key-press will increase or decrease the start time by 15 minutes.

Step 5 – Repeat steps 2–4 for the remaining start times and programs as necessary.

Step 6 – Return the function dial to RUN when ﬁnished.

IMPORTANT! A program which is set to start while a watering cycle is in progress will

be delayed (stacked) until the current watering cycle is completed. Any stacked programs that

are delayed past midnight will be canceled.