Operator's Manual

4.Iftheairgapisnotwithinthespeciedrange,
dothefollowing:
A.Loosenthenutthatsecuresthebeltguide
tothemotor(Figure39).
Important:Ensurethatthebeltguideis
towardthemotorpulley.
B.Rotatethebeltguideupordownuntilthere
isanairgapof2.5to4.0mm(3/32to5/32
inch)betweentheguideandeachbelt
(Figure39).
Important:Thebeltguideshouldnot
contactthebeltswiththeclutchleverin
theONposition.
Note:Iftheairgapbetweenthebeltguide
andbothbeltscannotbeattained,then1of
thebeltsistoolong.
C.Tightenthenutthatsecuresthebeltguide
tothemotor(Figure39).
D.Checktheclutchoperation;referto
CheckingtheClutchOperation(page31).
5.Installthedividerplate;refertoInstallingthe
DividerPlate(page26).
CheckingtheClutchOperation
ServiceInterval:Every40hours—Checktheclutch
operation.
Important:Thepaddlesmustnotrotateinan
emptydrumwhentheclutchleverisintheOFF
position.
1.MovetheclutchlevertotheOFFposition;refer
toControllingthePaddles(page21).
2.Startthemotor;refertoStartingtheMotor(page
21).
3.Ifthepaddlesrotatewiththeclutchlevertothe
OFFpositiondothefollowing:
A.Stopthemotor;refertoStoppingtheMotor
(page21).
B.Checktheairgapbetweenthebeltguide
andthebelts.
Note:Iftheairgapislargerthan4.0mm
(5/32inch),decreasethegapbetweenthe
beltguideandthebelts;refertoAdjusting
theBeltGuide(page30).
4.Repeatsteps1,2,and3untilthefollowing
conditionsaremet:
•TheclutchleverisintheOFFposition.
•Whilethemotorisrunning,thepaddlesdo
notrotateinanemptydrum.
AligningthePulleys
1.Removethedividerplate;refertoRemovingthe
DividerPlate(page25).
2.Placeastraightedgeacrossthefaceofthe
motorpulleyandtheidlerpulley(Figure40).
g020667
Figure40
1.Motorpulley
4.Idlershaft
2.Idlerpulley5.Locknut
3.Straightedge6.Setscrew
Note:Bothpulleysmustbealignedushwith
thestraightedge.
3.Ifthepulleysarenotaligneddothefollowing:
A.MovetheclutchlevertotheOFFposition.
B.Loosenthelocknutsandsetscrewsthat
securetheidlerpulleytotheidlershaft
(Figure40).
C.Usingasoft-facemallet,taptheidlerpulley
forwardorbackwardalongtheidlershaft
untilthemotorpulleyandtheidlerpulley
arealignedtothestraightedge(Figure40).
D.Tightenthesetscrewsandlocknutsthat
securetheidlerpulleytotheidlershaft
(Figure40).
4.Installthedividerplate;refertoInstallingthe
DividerPlate(page26).
31