Operator's Manual

C.Tightentheboltthatsecuresthebeltguide
totheengine(Figure65).
D.Checktheclutchoperation;referto
CheckingtheClutchOperation(page44).
8.Installthedividerplate;refertoInstallingthe
DividerPlate(page28).
CheckingtheClutchOperation
ServiceInterval:Every40hours
Important:Thepaddlesmustnotrotateinan
emptydrumwhentheclutchleverisintheOFF
position.
1.MovetheclutchlevertotheOFFposition.
2.Starttheengine.
3.Ifthepaddlesrotatewiththeclutchlevertothe
OFFpositiondothefollowing:
A.Shutofftheengine.
B.Checktheairgapbetweenthebeltguide
andthebelts.
Note:Iftheairgapislargerthan4.0mm
(5/32inch),decreasethegapbetweenthe
beltguideandthebelts;refertoAdjusting
theBeltGuide(page43).
4.Repeatsteps1through3untilallthefollowing
conditionsaremet:
•Theengineisrunat2/3throttle.
•TheclutchleverisintheOFFposition.
•Thepaddlesdonotrotateinanemptydrum
whiletheengineisrunning.
AligningthePulleys
1.Parkthemachineonalevelsurfaceandshut
offtheengine.
2.Allowthemachinetocool.
3.Disconnectthewirefromthesparkplug;referto
DisconnectingtheSpark-PlugWire(page28).
4.Removethedividerplate;refertoRemovingthe
DividerPlate(page28).
5.Placeastraightedgeacrossthefaceofthe
enginepulleyandidlerpulley(Figure66).
g020015
Figure66
1.Enginepulley
4.Idlershaft
2.Idlerpulley5.Locknut
3.Straightedge6.Setscrew
Note:Bothpulleysmustbealignedushwith
thestraightedge.
6.Ifthepulleysarenotaligneddothefollowing:
A.MovetheclutchlevertotheOFFposition.
B.Loosenthelocknutsandsetscrewsthat
securetheidlerpulleytotheidlershaft
(Figure66).
C.Usingasoft-facemallet,taptheidlerpulley
forwardorbackwardalongtheidlershaft
untiltheenginepulleyandidlerpulleyare
alignedtothestraightedge(Figure66).
D.Tightenthesetscrewsandlocknutsthat
securetheidlerpulleytotheidlershaft
(Figure66).
7.Installthedividerplate;refertoInstallingthe
DividerPlate(page28).
44