FORM NO. 3313-404 PART NO. 66-2200 PART NO. 66-2210 PART NO. §6-2220 INSTALLATION ) INSTRUCTIONS L WEIGHT TRANSFER KIT (For 52", 62" & 72" Cutting Decks) /] LOOSE PARTS CHART Qry.
_ Figure 2 1. Mounting bracket 2 Cap screw, Hat washer and lockout (2 per bracket} 3. Bracket angled up on 2200 4. 2200 front frame 4. FOR 62" & 72" CUTTING DECKS --To install & wait transfer kit on either a Grounds master 217D . or 220, use (4) 3/8" X cap screws and nuts to secure adapter bar directly to tractor frame. Use the correct existing mounting holes for the specific size deck (Fig. 1). Tighten cap strews and nuts to 45-50 ft. lbs. . Use (4) 3/8" X 7/8” cap screws and.
IMPORTANT: The top hole in the kens link bracket{s) must face to the rear (Fig. 7}, otherwise the weight transfer spring could fold incorrectly, going under the tractor frame when the deck is raised all the way. 1. Klee link bracket 2. Deck bravest 3. Shouter bok, washer and locket Figures 7 1.
8. The cutting unit performs best when the spring tension is adjusted sc that the cutting unit dose not ride too heavily on flat turf yet rides heavy enough {dose not bounce excessively) in uneven conditions, if the cutting unit scalps the turf or gives an uneven cut from one side to the other, thees may be too much weight on the deck and some weight should be transferred to the traction unit (ie.