Operator's Manual

The Toro Company – 1991, Rev. 1997

FORM NO. 3313–651 REV B

INSTALLATION

INSTRUCTIONS

PART NO. 68–9500

SNOW CAB KIT

IMPORTANT: Always install Snow Cab

Weight Kit (P/N 74-1190) when the Snow Cab

Kit is installed. The Weight Kit is required

for the 624, 824, 828 and 1028 Power Shift

snowthrowers when the optional cab is

installed (also recommended

for 1132 and

1232 Power Shift snowthrowers). The kit

helps prevent the front end of the

snowthrower from riding up when wheels are

in the forward position.

Note: Do not tighten mounting bolts until all

parts of the cab have been installed.

1. Remove (2) screws securing lever cover to right

handle (Fig. 1).

m-3168

Figure 1

1. Lever cover

2. Remove (2) flange head capscrews securing

control panel to handles (one on each side) and

loosely secure attaching bracket base to handles

with flange head capscrews removed (Fig. 2).

m-3169

Figure 2

1. Control panel

2. Approximately 1/4”

3. Attaching bracket base

4. Flange head capscrew

3. Pivot attaching bracket base rearward until there

is approximately /” space between bracket and

control panel, then tighten flange head capscrews

securing bracket to handles (Fig. 2).

4. Reinstall new lever cover to right handle with (2)

screws previously removed (Fig. 3).

PAGE 1
FORM NO. 3313–651 REV B SNOW CAB KIT INSTALLATION INSTRUCTIONS PART NO. 68–9500 IMPORTANT: Always install Snow Cab Weight Kit (P/N 74-1190) when the Snow Cab Kit is installed. The Weight Kit is required for the 624, 824, 828 and 1028 Power Shift snowthrowers when the optional cab is installed (also recommended for 1132 and 1232 Power Shift snowthrowers). The kit helps prevent the front end of the snowthrower from riding up when wheels are in the forward position. Note: 1. 2.
PAGE 2
/ -20 x 2” lg. capscrew and locknut. Control cables to be routed outside of clamp. Repeat procedure on left side of machine. 7. Mount horizontal curved bow and corner posts to front legs of attaching brackets with (2) / -20 x / ” lg. capscrews (capscrew heads inside the cab) and locknuts (Fig. 5). Welded clips on curved bow to be positioned between the corner posts and attaching bracket with the posts on the inside. 8.
PAGE 3
each side of framework and locknut. Tighten fasteners and install red caplugs over exposed threads. 12. Carefully unfold and snap vinyl enclosure over the top frame (Fig. 8). 1 1 2 2 3 3 m-3175 m-3173 Figure 6 1. Vertical bow 2. Horizontal curved bow Figure 8 1. Plastic top 2. Vinyl shell 3. Corner post 13. Tie bottom of shell around control cables (Fig. 8). 10. Mount the top frame to the rear vertical bow and to the upper ends of the front posts with (4) / -20 x / ” lg.
PAGE 4