Operator's Manual

Setup
1
InstallingtheTow
Pole—Models68004C,68006C,
and68009C
Partsneededforthisprocedure:
1
Towpolekit(soldseparately)
InstallingtheTowPoletotheMachine
Note:Thetowpoleispurchasedseparately.SeeyourToro
authorizeddealerforthetowpoleoptionsforyourmachine.
Themachinehasthefollowingtowpoleoptions:
HitchTypeLength
50mm(2inch)ball—stamped78.7cm(31inches)or127cm
(50inches)
50mm(2inch)ball—forged78.7cm(31inches)or127cm
(50inches)
Pintle
78.7cm(31inches)or127cm
(50inches)
1.Removetheboltandnutfromthetowpole(Figure4).
5
1
2
4
6
3
G019804
Figure4
1.Towpole4.Bolthole
2.Frontpost
5.Frametting
3.Bolt6.Nut
2.Slidethetowpoleforwardandaligntheholeinthe
polewiththeholeintheframetting(Figure4).
3.Inserttheboltthroughtheholesinthettingandthe
pole(Figure4).
4.Threadthenutontotheboltandtightenthemuntil
theyaretightagainsttheframetting(Figure4).
Note:Iftheself-lockingnyloninsertinthelocknut
wearswithuse,replacethenutwithanewGrade5or
Grade8locknut.
2
InstallingtheTongue—Models
68007Cand68008C
Partsneededforthisprocedure:
1
Towpolekit(soldseparately)
InstallingtheTonguetotheMachine
Note:Thetowpoleispurchasedseparately.SeeyourToro
authorizeddealerforthetow-poleoptionsforyourmachine.
1.Lowertherearstabilizerlegsforsafety;referto
LoweringtheStabilizerLegs(page20).
2.Placejackstandsunderthefrontframerailtoprevent
themachinefromtippingforward(Figure5).
WARNING
Mechanicalorhydraulicjacksmayfailto
supportthemachineandcauseseriousinjury.
Usejackstandswhensupportingthemachine.
G021091
1
Figure5
1.Supportpoints
3.Removethe2nutsandboltsthatsecurethefront
stabilizerlegtotheframe(Figure6),andremovethe
frontstabilizerleg.
9