Operator's Manual

4.Measurethedistancefromthebelttothestraightedge.

Thedistanceshouldbeapproximately1cm(13/32

inch)asshowninFigure53.

Note:Ifthebelttensionneedsadjustment,referto

AdjustingtheDrive-beltTension(page37).

5.Installthedividerplate;refertoInstallingtheDivider

Plate(page29).

AdjustingtheDrive-belt

Tension

1.Shutofftheengineandwaitforallmovingpartsto

stop.

2.Removethedividerplate;refertoRemovingthe

DividerPlate(page29).

3.Loosenthe4nutsandboltsthatsecuretheengineto

theenginemountingplate(Figure54).

G019732

Figure54

1.Enginemountingnutsandbolts(4each)

4.Slidetheenginelefttoincreasetensiononthedrive

beltorrighttodecreasetension.

5.Checkthedrive-belttension;refertoCheckingthe

Drive-BeltTension(page36).

Note:Whenthebeltshavetheappropriateamount

oftension,torquethe4nutsandboltsto24N∙m(18

ft-lb)each.

6.Installthedividerplate;refertoInstallingtheDivider

Plate(page29).

ReplacingtheDriveBelts

ServiceInterval:Every100hours

Note:Themachinehas2drivebelts.Remembertobuy2

beltsforreplacement.

1.Completesteps1through3inAdjustingtheDrive-belt

Tension(page37).

2.Slidetheenginetotherighttodecreasethebelttension.

3.Removethedrivebeltsfromthepulleys.

4.Installthenewdrivebeltsonthepulleys.

5.Slidetheenginetotheleftuntilthebeltshavethe

correcttension;refertoCheckingtheDrive-Belt

Tension(page36).

6.Torquethe4mountingnutsandboltsto24N∙m(18

ft-lb)each(Figure54).

7.Installthedividerplate;refertoInstallingtheDivider

Plate(page29).