Reference Guide

Revision 1 04-01-2021 Toro Form No 3446-962 Rev A

Tool Inspection Process

Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete

procedures, refer to the Operator’s Manual):

Maintenance Service Interval Maintenance Procedure

Before each use or daily • Inspect the tires and wheels.

• Check the engine oil level.

• Inspect the air-cleaner elements.

After each use

• Torque the lug nuts to 108 to 122 N∙m (80 to 90 ft-lb) after towing.

• Clean the drum.

After the first 25 hours Change the engine oil.

Every 20 hours

Inspect the drive-belt tension and adjust it as necessary. Replace the drive belts if they show any signs of wear,

cracks, glazing, or damage.

Every 50 hours

Clean the air-cleaner elements. Clean them more frequently in dusty operating conditions.

Every 100 hours

• Change the engine oil.

Tool Rental Center

Tool Turn Guide

CM-958H-P Concrete Mixer

Model No. 68009HD—316000001 and Up

Supplier Technical Support #:

800-888-9926 (US and Canada)

Supplier Website: www.Toro.com

PURPOSE

Follow the directions below to maintain this tool.

SAFETY

Refer to the product Operator’s Manual for complete safety information.

PAGE 1
Tool Turn Guide Tool Rental Center PURPOSE CM-958H-P Concrete Mixer Model No. 68009HD—316000001 and Up Supplier Technical Support #: 800-888-9926 (US and Canada) Supplier Website: www.Toro.com Follow the directions below to maintain this tool. SAFETY Refer to the product Operator’s Manual for complete safety information.
PAGE 2
Maintenance Service Interval Maintenance Procedure • Check the spark plug. • Clean the spark arrester. • Clean the sediment cup. • Replace the drive belts. Every 300 hours • Replace the paper air-cleaner element. Replace it more frequently in dusty operating conditions. • Replace the spark plug. Monthly Grease the trunnions and the drum spindle. Yearly or before storage Clean the fuel sediment cup. Important: Refer to the Engine Operator' s Manual for additional maintenance procedures.
PAGE 3
Spring Maintenance Tool Rental Center PURPOSE Guide CM-958H-P Concrete Mixer Model No. 68009HD—316000001 and Up Supplier Technical Support #: 800-888-9926 (US and Canada) Supplier Website: www.Toro.com Follow the directions below to maintain this tool. SAFETY Refer to the product Operator’s Manual for complete safety information.
PAGE 4
Recommended Routine Maintenance: Step Action 1 Change the engine oil. 2 Replace the air filter. 3 Replace the spark plug. 4 Clean the fuel-sediment cup. 5 Grease the trunnions and the drum spindle. 6 Grease the wheel bearings.