Reference Guide
Revision 1 04-01-2021 Toro Form No 3446-960 Rev A
Tool Inspection Process
Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete
procedures, refer to the Operator’s Manual):
Maintenance Service Interval Maintenance Procedure
Before each use or daily • Inspect the tires and wheels.
• Check the engine-oil level.
• Inspect the air-cleaner elements.
After each use
• Torque the lug nuts to 108 to 122 N∙m (80 to 90 ft-lb) after towing.
• Clean the drum between mixing batches of material.
• Lubricate the trunnions.
• Clean the machine.
After the first 25 hours • Change the engine oil.
• Inspect the belts and adjust as necessary.
Every 40 hours
• Inspect the belts and adjust as necessary.
Tool Rental Center
Tool Turn Guide
MM-858H-P Mortar Mixer
Model No. 68021HD—316000001 and Up
Supplier Technical Support #:
800-888-9926 (US and Canada)
Supplier Website: www.Toro.com
PURPOSE
Follow the directions below to maintain this tool.
SAFETY
Refer to the product Operator’s Manual for complete safety information.