Operator's Manual

Chapter 7
Troubleshooting
The machine does not start.
Possible Cause Corrective Action
The batteries need to be charged. 1. Check the InfoCenter for the battery
status.
2. Charge the machine.
The electrical service disconnect switch is in
the
OFF position.
Turn the electrical service disconnect switch
to the ON position.
The emergency stop switch is engaged. Disengage the emergency stop switch.
The machine does not drive.
Possible Cause Corrective Action
The machine has been inactive for more
than 30 seconds and is in sleep mode.
Set the drive control in the
NEUTRAL position
and back to the preferred direction.
One or more of the electrical connections
are loose.
Check and tighten any loose connections.
The machine batteries do not charge.
Possible Cause Corrective Action
The electrical service disconnect switch is in
the
OFF position.
Turn the electrical service disconnect switch
to the ON position.
The charging cord plug is not fully plugged
in.
Ensure that both sides of the charging cord
is fully plugged in.
The charger is bad. Contact your Authorized Service Dealer.
The hopper is not functioning properly.
Possible Cause Corrective Action
The hydraulic fluid is low. Check the hydraulic fluid.
There is air in the hydraulic system. Bleed the air out of the hydraulic system.
3440-398 A Page 7–1 Troubleshooting