Operator's Manual

BeltMaintenance
CheckingtheBelt,Pulley
Alignment,BeltTension,
andBelt-GuideGap
ServiceInterval:Every40hours
1.Removethebeltguard;refertoRemovingthe
BeltGuard(page19).
2.MovetheDyna-ClutchlevertotheSTOPposition.
3.Checktheconditionofthebeltforwearor
damage.
Note:Ifthebeltiswornordamaged,replace
thebelt;refertoRemovingtheBelt(page20)
andInstallingtheBelt(page20).
4.MovetheDyna-ClutchlevertotheRUNposition.
5.Checkthatthebeltisalignedstraightbetween
pulleys.
Note:Ifthebeltdoesnotrunstraightbetween
pulleys,alignthepulleys;refertoAligningthe
Pulleys(page20).
6.Checkthatthebelthasenoughtensiontoatten
itbetweentheenginepulleyandthebelttension
pulley.
Note:Ifbelttensionistoolow,adjustthe
tensionofthebelt-tensionpulley;referto
AdjustingtheDyna-Clutch(page20).
7.Measurethegapbetweenthebeltandthebelt
guide.Theairgapshouldbeapproximately6
mm(1/4inch).
Note:Iftheairgapislargerorsmallerthan6
mm(1/4inch),adjustthebeltguide(Figure26);
refertoAdjustingtheBeltGuide(page21).
8.Installthebeltguard;refertoInstallingtheBelt
Guard(page19).
RemovingtheBeltGuard
1.Removethe2hex-washerheadbolts(5/16x1
inch)thatsecurethebeltguardtothebelt-guard
bracket(Figure22).
g024872
Figure22
1.Hex-washerheadbolt3.Belt-coverbracket
2.Beltcover
2.Pullthebeltguardawayfromtheengineand
thenup(Figure22).
InstallingtheBeltGuard
1.Aligntheholesinthebeltguardwiththeholesin
thebelt-coverbracket(Figure22).
2.Securethebeltguardtothebracketwiththe2
hex-washerheadbolts(5/16x1inch).
19