Operator's Manual

InstallingtheBelt
1.Alignthebeltovertheclutch(Figure37).
2.Pullthebelttowardtheeccentricpulley(Figure36).
3.Slipthebeltovertheshoulderoftheeccentricpulley
(Figure36).
Note:Rotatetheeccentricpulleybyhandtohelp
installthebelt.
AdjustingtheBelt
1.Attheclutch,alignthebeltagainstthexedcone.
Note:Useaatbladedscrewdrivertopositionthe
beltagainstthexedcone.
G020967
1
2
3
4
Figure38
1.Fixedcone
3.0.76to1.27mm(0.03to
0.05inch)gap
2.Belt
4.Slidingcone
2.Measurethegapbetweenthebeltandtheslidingcone
(Figure38).Ifthegapis0.76to1.27mm(0.03to0.05
inch),skiptostep6.
3.Loosentheboltsandnutsthatsecuretheenginetothe
enginedeck(Figure39).
213 1
1 2 13
G020966
4
Figure39
1.Bolt3.Enginedeck
2.Nut4.Eccentricpulley
4.Adjustthegapbetweenthebeltandtheclutchas
follows:
•Movetheengineawayfromtheeccentricpulleyto
reducethegapbetweenthebeltandthesliding
cone(Figure39).
•Movetheenginetowardfromtheeccentricpulley
toincreasethegapbetweenthebeltandthe
slidingcone(Figure39).
5.Whenthegapmeasurementiswithinthe0.76to1.27
mm(0.03to0.05inch)range(Figure38),tightenthe
boltsandnutsthatsecuretheenginetotheenginedeck
to18N-m(13lb-ft).
6.Installthebeltguard;refertoInstallingtheBeltGuard
(page25).
26