Form No. 3377-604 Rev B Trailer Light Kit End-Dump Mixers Model No. 68063 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped.
1 2 Installing the Brackets Installing the Wires Parts needed for this procedure: Parts needed for this procedure: 1 Left bracket 1 Wire harness 1 Right bracket 8 Cable clamp 4 Bolt 5 Short bolt 4 Nut 5 Nut 2 Large grommet 1 Small grommet 4 Cable tie Procedure 1. Align the bolt holes on the end of the long side of the left bracket (L-shaped) with the bolt holes in the left side of the frame, near the handwheel (Figure 1). Procedure Note: For older models, drill 2 holes (7.
1 G021014 Figure 3 Push mount 1 G02101 1 3 2 2 1. Edge clips 4 Figure 4 1. Push mounts 3. Tongue 2. Wire harness 4. Edge clip 2 3. Wire harness 2. Cable clamps G021009 3 1 Figure 5 Frame underside shown for clarity 6. Use cable clamps and the pre-installed edge clips to secure the wire harness along the inside of the frame (Figure 6). 1 2 3. Route the front of the wire harness through the tongue handle (Figure 4). G020912 Note: For older models, drill 5 holes (6.
1 3 Installing the Lights Parts needed for this procedure: G021023 Figure 7 1. Push mounts 8. Push the pre-installed push mount near the green wire into the open hole closest to the bolts, in the right light bracket (Figure 8). 1 Left light 1 Right light 1 Center light 1 Center-light harness 1 License-plate holder 2 Long bolt 6 Nut 1 Cable tie Installing the Side Lights 1 1.
1 5. Push the wires into the appropriate holes in the light (Figure 10). Note: If you need to remove a wire from the light, insert the end of a paper clip into the small hole under the wire, then pull the wire out. 6. Repeat steps 3 through 6 for the light on the right side of the machine. G021018 3 1 2 Figure 13 1. Bolt holes 2. Center light 2 3.
4 5 Installing the Reflectors Replacing the Light Bulbs Parts needed for this procedure: No Parts Required 2 Reflector 2 Short bolt Replacing the Rear-facing Side Bulbs 2 Nut Note: The left rear-facing bulb also illuminates license plate. 1. Use a screwdriver to remove the 4 screws from the large square lens on the light (Figure 17). Procedure 1. Align the hole in a reflector to the hole in 1 side of the tongue of the machine (Figure 16). A B C D E F Note: For older models, drill a 7.
A B C D E F G020830 Figure 18 2. Remove the lens (Figure 18). 3. Pull the bulb out of the socket (Figure 18). 4. Push a new 168 bulb into the socket (Figure 18). 5. Install the lens and the 2 screws (Figure 18). Replacing the Center Bulbs Note: Each center bulb is integrated into the lens. 1. Push 1 of the tabs over that holds the lens assembly in place, and pull the lens away from the rest of the center-light assembly (Figure 19). A B C G021019 Figure 19 2.
