Addendum

ManualsBrandsToro ManualsMixersToro 68131

FormNo.3381-180RevA

TowPoleHitchKit,Pintel,Stamped,1inPin

End-DumpConcreteMixer

ModelNo.68130

ModelNo.68131

ModelNo.68132

Addendum

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

TowPole1

Clevispinandcable

Screw(10-24x5/8inch)

Locknut(10-24inch)

Attachtheclevispinandcabletothe

towpole.

Hitchassembly1

Flanged-headbolt(1/2x4-1/2inch)

Washer(1/2inch)

Locknut(1/2inch)

Shimthehitchassembly.

Note:Ifnecessary,attachtheclevispinandcabletothetow

pole,andasneeded,shimthehitchassemblybeforeinstalling

thetowpoleontothemachine.

AttachingtheClevisPinand

CabletotheTowPole

Partsneededforthisprocedure:

1TowPole

Clevispinandcable

Screw(10-24x5/8inch)

Locknut(10-24inch)

Procedure

Usethisprocedureiftheclevispinandlanyardisnotfactory

installedonthetowpole.

1.Aligntheholeinthemountingtabofthecabletothe

4.7mm(3/16inch)holeinthetopofthetowpole

(

Figure1).

Note:Ensurethatthecablepointstowardthe

mountingbracketofthetowpoleandisangled45°to

thesideasshowninFigure1.

Figure1

1.Mountingbracket(tow

pole)

4.Mountingtab(cable)

2.45°

5.Hole

3.Screw(10-24x5/8inch)6.Locknut(10-24)

2.Securethemountingtabofthecabletothetotowpole

withthescrew(10-24x5/8inch)andlocknut(Figure

1).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUS

AllRightsReserved

*3381-180*A

Summary of content (2 pages)

PAGE 1
Form No. 3381-180 Rev A Tow Pole Hitch Kit, Pintel, Stamped, 1 in Pin End-Dump Concrete Mixer Model No. 68130 Model No. 68131 Model No. 68132 Addendum Setup Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
. Partially insert the 2 flanged-head bolt (1/2 x 4-1/2 inch) through the holes in the mounting plate with 3.1 mm (1/8 inch) of the threads projecting to the inside of the bracket (Figure 3). 2 Shimming the Hitch Assembly Parts needed for this procedure: 1 Hitch assembly 2 Flanged-head bolt (1/2 x 4-1/2 inch) 2 Washer (1/2 inch) 2 Locknut (1/2 inch) Procedure Use this procedure to reduce the gap between the mounting plate of the tow pole and the hitch assembly.