Installation Instructions

ManualsBrandsToro ManualsMixersToro 68131

FormNo.3379-218RevA

TowPoleHitch

forEnd-DumpConcreteMixers

ModelNo.68130

ModelNo.68131

ModelNo.68132

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

Thisproductcontainsachemicalorchemicals

knowntotheStateofCaliforniatocausecancer,

birthdefects,orreproductiveharm.

Safety

SafetyandInstructional

Decals

Safetydecalsandinstructionsareeasily

visibletotheoperatorandarelocatednear

anyareaofpotentialdanger.Replaceany

decalthatisdamagedorlost.

125–8216

1.ReadtheOperator’s

Manualforinformationon

howtotowthemachine.

2.Warning—limittowing

speedtolessthan55mph

/88km/h.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3379-218*A

Summary of content (4 pages)

PAGE 1
Form No. 3379-218 Rev A Tow Pole Hitch for End-Dump Concrete Mixers Model No. 68130 Model No. 68131 Model No. 68132 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
PAGE 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty. Tow pole Front stabilizer leg (shipped with the machine) Short bolt Long bolt Locknut Hitch assembly Flange-head bolt Locknut Safety chain Connecting link 1 1 6 1 7 1 2 2 1 2 Install the tow pole. Install the hitch assembly. Install the safety chain and connecting links.
PAGE 3
2 Installing the Hitch Assembly Parts needed for this procedure: 1 Hitch assembly 2 Flange-head bolt 2 Locknut G023350 Procedure Figure 3 1. Using 2 flange-head bolts and 2 locknuts, loosely install the hitch assembly in the middle position of the mounting plate. 5. Align the top rear hole in the front stabilizer leg (Figure 4) to the rearmost hole near the handle at the front of the tow pole. 1 2 1 4 3 2 G023352 Figure 5 Ball hitch shown 3 1. Locknut (2) 3. Flange-head bolt (2) 2.
PAGE 4
A 1 1 B 2 3 2 C D 4 3 3 G023353 Figure 6 Ball hitch shown 1. Top position G023355 Figure 7 3. Bottom position 2. Middle position Important: Refer to the machine Operator’s Manual for information about hitching and towing the machine. Note: Ensure that approximately equal lengths of safety chain extend from either side of the tow pole. Installing the Safety Chain and Connecting Links Parts needed for this procedure: 2 Connecting link 4. Connecting link 3.