Operator's Manual

Lifting the Machine
Ensure that the hopper is empty before lifting the machine.
G194436
1. Place the platform in the raised position.
2. Hoist the machine using the 2 lift points under
the hopper
and the 2 rear tie-down points
. Tilt the hopper forward to locate the 2 lift
loops and attach a chain or straps at each of
the loops.
Note: Take up the slack in the chain or straps
to properly balance the unit.
Releasing the Cushion for Rear Access
1. Lower the platform.
2. Loosen the twist knobs
on each side of the machine.
g032556
3. Remove the cushion and lower it to the
platform.
4. Perform any maintenance or adjustment on
the machine.
5. Raise the cushion, and slide it onto the pins on
both sides of the machine.
6. Tighten the twist knobs.
3451-705A Page 5–4 Maintenance: Pre-Maintenance Procedures