Operator's Manual
Table Of Contents
- MB TX 2500 Tracked Mud Buggy
- Disclaimers and Regulatory Information
- 1: Introduction
- 2: Safety
- 3: Product Overview
- 4: Operation
- 5: Maintenance
- 6: Storage
- 7: Troubleshooting
Drive Belt
Inspecting the Drive Belt
1. Park the machine on a level surface, move the motion-control levers to the NEUTRAL-LOCK
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Release the cushion and remove the fuel tank.
4. Inspect the belt. Replace the belt if it is worn.
Note: The signs of a worn belt include squealing while the belt is rotating, frayed edges,
burn marks, and cracks on the belt.
G189546
Extension spring
Belt
Replacing the Drive Belt
1. Park the machine on a level surface, move the motion-control levers to the NEUTRAL-LOCK
position, engage the parking brake, and lower the hopper.
2. Shut off the engine, and remove the key. Allow the engine to cool.
3. Release the cushion and remove the fuel tank.
4. Raise the rear of the machine and support the machine on jack stands.
5. Remove the skid plate.
G325648
Rear bolt (2)
Skid plate
Side bolt (4)
6. Remove the extension spring.
Maintenance: Drive System Maintenance Page 5–19 3451-705A