Addendum

International English (GB)
FORM NO. 3322–593
Model No. 70171–9900001 & UP
Operator’s Manual
ADDENDUM
The following instructions have been revised. Keep this sheet with the Operator’s Manual for reference.
Loose Parts
DESCRIPTION QTY. USE
Seat
Wire Tie
Clamp
Seat Spacer (rubber)
Seat Spacer (metal)
Washer , 5/16” I.D.
Screw , 5/16”–18 x 1 1/2” (38 mm)
Locknut
1
1
1
2
2
2
2
2
Install Seat
Front Wheel Assembly
Flat W asher
Hub Cap
Cotter Pin
2
2
2
2
Install Front Wheels
Steering Wheel
Roll Pin
Steering Shaft Cover
1
1
1
Install Steering Wheel Assembly
Capscrew
Wing Nut
2
2
Secure battery cables to battery
Install Seat
1. Thread 2 seat spacers (rubber) into bottom of
seat (Fig. 1) in rear holes.
2. Position seat onto seat base, inserting seat switch
cable thru slot and spacer studs through the rear
mounting holes (Fig. 1). Secure loosely with two
5/16” locknuts.
3. Slide wire clamp over seat switch wire (Fig. 1).
4. Install 2 metal spacers in line with the front
holes. Insert a 5/16” x 1 1/2” (38 mm) screw
through the wire clamp and a 5/16” flat washer.
Insert this screw through the seat bracket and
spacer into the left front seat hole (Fig. 1).
Install another 5/16” x 1 1/2” (38 mm) screw
with a flat washer into the right front seat hole.