Form No. 3359-686 Rev A G132 and H132 Rear-Engine Riding Mower Model No. 70185 Model No. 70186 Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 5 6 7 8 9 10 11 © 2007—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Description Use Qty.
Procedure 12 Description Use Qty. Operator’s Manuals (English and French) Engine operator’s manual Keys Spark plug wrench Oil drain tube Recycler® cover 2 1 2 1 1 1 1 Read the manual before operating or servicing the mower.
4 Attaching the Steering Wheel Installing the Engine Cover Parts needed for this procedure: Parts needed for this procedure: 1 Socket pin 1 Engine cover 2 Screws, M6 x 25 mm Procedure Procedure 1. Rotate the steering wheel upward until it is aligned with the steering column. 1. Slide the tabs on the engine cover into the slots on the body of the tractor (Figure 4). 2. Secure the steering wheel with the socket pin (Figure 3). Figure 3 1. Socket pin Figure 4 1. Engine cover 2. Screw 2.
5 6 Assembling the Grass Collector Installing the Grass Collector Parts needed for this procedure: Parts needed for this procedure: 2 Z-brackets 1 Frame 2 Bolts, M6 x 35 mm 1 Fabric bag with clips 2 Spacers 1 Handle 2 Washers 2 Locknuts, M8 2 Nuts, M6 4 Washers, M9 1 Grass collector cover 2 Pins 1 Full bag lever Procedure 1. Slide the bag onto the frame and secure it with the clips (Figure 5). Procedure 1.
Battery electrolyte contains sulfuric acid, a deadly poison that can cause severe burns. • Do not drink electrolyte and avoid contact with skin, eyes or clothing. Wear safety glasses to shield your eyes and rubber gloves to protect your hands. • Fill the battery where clean water is always available for flushing the skin. Figure 8 1. Bolt (M6 x 35 mm) 2. Z-bracket 3. Spacer • Follow all instructions and comply with all safety messages on the electrolyte container. 4. Grass collector 5. Washer 6.
9 Charging the battery produces gasses that can explode. Filling the Fuel Tank Never smoke near the battery and keep sparks and flames away from battery. No Parts Required 8. When the battery is fully charged, unplug the charger from the electrical outlet, then disconnect the charger leads from the battery posts (Figure 11). Procedure Add fuel to the fuel tank; refer to Filling the Fuel Tank in the Operator’s Manual. 10 Checking the Tire Pressure No Parts Required Figure 11 1. Positive post 2.
12 Reading the Manual Parts needed for this procedure: 2 Operator’s Manuals (English and French) 1 Engine operator’s manual 2 Keys 1 Spark plug wrench 1 Oil drain tube 1 Recycler® cover Procedure • Read the Operator’s Manual. • Read the engine owner’s manual. • Use the ignition key to start the engine and the KeyChoice key to operate the mower in reverse (refer to the Operator’s Manual). • Use the spark plug wrench to service the spark plug (refer to the Operator’s Manual).
