FORM NO. 3317-209 WHEEL HORSE® LAWN TRACTOR mRO WITH 32" AND 38" MOWERS o L MODEL NO. 71182 5910001 & UP SET-UP MODEL NO. 71184 5910001 & UP MODEL NO. 71191 ~ 5910001 & UP INSTRUCTIONS Loose Parts Note: Use the chart below to verify all parts have been shipped. DESCRIPTION QTy. USE Front Whee! 2 Flat Washer 2 Hub Cap 2 Install front wheels. Cotter Pin 2 Steering Wheel 1 Foll Pin 4 Install steering wheel, Seat 1 Knob 1 install the seat. Flat Washer 1 Key 1 Use in ignition switch.
Set-Up Instructions Install Front Wheels 3. Doter If wheels arc already installed, refer to Check Tire Pressure (below). Install wheel onto axle with valve stem out. Slide the flat washer onto the axle. Insert cotter pin through the axis and bend the ends of the pin apart (Fig. 1). Push the hub cap (Fig. 1) onto the end of the axle. Figure 1 1. Flat washer 3. Hubcap 2. Softer pin 4. Repeat steps 1-3 on opposite side. 5. Grease the wheel bearings.
5. Secure the seat switch wire cable to scat base with wire clip (Fig. 3). Note: Check seat switch wire is routing, it must not be pinched in seat brackets. Set-Up Instructions 4\ pang Er POTENTIAL HAZARD * Battery electrolyte contains sulfuric acid which is & deadly prison and it causes severe burns.
Set-Up Instructions Leave the filler caps off and connects 310 4 amp battery charger to the battery posts (Fig. 5). Charge the battery at a rate of 4 amperes or less for 4 hours (12 volts). Figure 5 . Positive post 3. Charger red wire 2. Naive post 4. Charger black wire FIELDING POTENTIAL HAZARD * Charging battery produces gasses. WHAT CAN HAPPEN * Battery gasses can explode, HOW TO AVOID THE HAZARD * Keep cigarettes, sparks sud flumes away from battery, 4.
Purge Hydro Trans axle (Hydro Drive Tractors Only) During handling and shipping air can be introduced into the hydro transient. To achieve proper performance all trapped air must be removed. 1. Place tractor on a flat level surface. 2. Place the drive control in the “Push” position (Fig. 6). Figure 6 1. Persist position 2. Push position 3. Run engine at a fow idle and move traction control pedal forward for five (5) seconds then reverse for five (5) seconds. Repeat three (3) times. 4.
Se-Up Instructions Check Traction Control Pedal (Hydro Drive Tractors Only) After adjusting the hydro neutral position it is necessary to check the traction control pedal. While pressing the control pedal full forward and full reverse it must not contact the footrest pad before hitting the stop(s) at the trans axle (Fig. 7). LI contact is made with the foot pad in either direction, forward or reverse, adjustment is required. 2. Loosen the cap screws below the right footrest.
Set-Up Instructions Test Drive the Tractor Make sure all electrical and mechanical systems are operating properly.