( INSTALLATION h PART NO. 72-2700 FORM NO. 3313-781 INSTRUCTIONS TOR SETTING UP INSTRUCTIONS Note: This kit is required to mount a Easy-Empty Rags Catcher Kit, Model 89111, on a HMR 1200 with a 38” cutting deck. Mount Support Brackets 1. Loosely secure support brackets to rear of rider frame with (4) cap screws (7/8” ig.) and lockouts. Support brackets to be positioned as shown in fig. 1.
SETTING UP INSTRUCTIONS Note: Try to open basket door when handle is pushed in completely. if basket opens, lift handle is not pushed in far enough or basket is not closed tightly. 4. Position notches on bag hangers on rod of bag support (Fig. 4}, Rotate grass basket up so mounting pins line up with mounting holes in support brackets (Fig. 4}. Push pins through holes and retain with hair pin cotters (Fig. 4).
OPERATING INSTRUCTIONS One condition that may affect the “conveying” of grass clippings from the mower housing to the grass basket is when the mower housing is set too low. Since air is required to propel grass clippings, there must be a source for this air. If the source is obstructed, conveying will be inefficient. Thus. the height-of-cut must not be set too low, because grass surrounding the mower housing will prevent air from getting under the housing and entering the conveying system.