Service Manual

29.Remove bearing(93), spacer(89), PTO gear cmp,
clutch cylinder cmp(78), three rods(90) and key(92) from
PTO cmp. [Fig.32]
30.Remove two bearings(93), ring(87) and gear(77) from
PTO gear cmp. [Fig.33]
31.Remove bearing(57), B-plate(96), C-plate(97),
three A-plates(95), three friction plates(98), two seal rings
(56) and PTO shaft(75). [Fig.33]
*Do not drop gear(77), shaft(75) and bearings(57)(93).
*Avoid damage of machined surfaces(gear(77), shaft(74)).
*If damage is detected, seal ring(56) must be replaced.
Fig.32
Fig.31
X3
Fig.33
PTO cmp
92
X3
90
78
89
93
93
87
77
X2
PTO gear cmp
96
97
98
95
X3
56
X2
75
57
PTO gear cmp
PTO cmp
10