Service Manual

HGM-H 13
AXLE HUB ASSEMBLY
9
10
11
18
17
Refer to Figure 4
1. Remove the axle cap and discard (9).
2. Remove the cotter pin and discard (18).
3. Remove the castle nut (10).
4. Remove the taper hub assembly (11) and
discard.
NOTE: A new hub will have to be ordered
to replace the discarded hub.
5. Remove the axle shaft key (17).
Inspection
1. Check all components for excessive wear
or damage. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the castle nut (10)*, refer to
the table on page 11 for the required torque
values.
NOTE: As a general rule, use the low end of the
torque specication . Once at the speci-
ed torque, rotate castle nut clockwise
to align with nearest cotter pin hole.
*SEE PAGE 22 FOR ALTERNATE
TORQUE METHOD.
Figure 4, Hub Assembly