Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 72071



The T

oro Company – 1999

Printed in USA

FORM NO. 3322-970

SET UP

INSTRUCTIONS

MODEL

NO. 72071–200000001 & UP

MODEL NO. 72107–200000001 & UP

MODEL NO. 72116–200000001 & UP

LAWN & GARDEN TRACTOR

Loose

Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Front Wheel

Flat W

asher-large OD

Shim W

asher

Dust Cover

Cotter Pin

Install front wheels.

Rear Wheel

Wheel Bolt

Install rear wheels.

Steering Wheel

Lock W

asher 1/2”

Nut 1/2”

Logo Cover

Install steering wheel.

Seat

Spacer-small ID

Spacer-large ID

Shoulder Bolt

Knob

Flat W

asher

Install the seat.

Bolt 1/4–20 x 3/4”

Wing Nut-plastic 1/4”

Attach battery cables.

Key 1

Use in ignition and “Key Choke” switches.

Operator’

s Manual

Read manual before operating tractor

Summary of content (8 pages)

PAGE 1
FORM NO. 3322-970 LAWN & GARDEN TRACTOR MODEL NO. 72071–200000001 & UP MODEL NO. 72107–200000001 & UP MODEL NO. 72116–200000001 & UP SET UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY.
PAGE 2
Set Up Instructions Install Front Wheels Note: Install Rear Wheels If wheels are already installed, refer to Check Tire Pressure (below). 1. Slide wheel onto axle with valve stem in. (Fig. 1). 2. Wheel end play should be 0-.015” (0-.4 mm). Use shim washers (as required) and large OD flat washer for spacing on the axle. Insert cotter pin through the axle and bend the ends of the pin open (Fig. 1). 3. 1. Install wheel onto axle with valve stem to the inside (Fig. 2). 2.
PAGE 3
Set Up instructions Install Steering Wheel Install Seat 1. Position front wheels straight ahead. 2. Remove logo cover by releasing (3) latches from back side with screwdriver. 3. 4. Note: Line up center spoke toward the seat and position the steering wheel onto shaft spline (Fig. 3). Secure steering wheel with lockwasher and nut (Fig. 3). 5. Torque steering wheel nut to 50 ft-lbs (37 N.m). 6. Snap logo cover into place (Fig. 3). 1.
PAGE 4
Set Up Instructions Activate the Battery 1 Bulk electrolyte with 1.260 specific gravity must be purchased from a local battery supply outlet. 1. Remove the battery from the tractor: refer to Operator’s Manual, Removing the Battery. 2 IMPORTANT: Be careful not to damage the long vent tube when removing the battery box. 3 1262 Figure 5 POTENTIAL HAZARD • Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns.
PAGE 5
Set Up instructions Check Safety System POTENTIAL HAZARD • Charging battery produces gasses. WHAT CAN HAPPEN • Battery gasses can explode. Refer to the Operator’s Manual, Checking Safety System. Test Drive the Tractor HOW TO AVOID THE HAZARD • Keep cigarettes, sparks and flames away from battery. 4. When the battery is fully charged, disconnect the charger from the electrical outlet then from the negative and positive battery posts (Fig. 6). 5.
PAGE 6
Set Up Instructions 6
PAGE 7
Set Up instructions 7
PAGE 8
Set Up Instructions 8