Operator's Manual

AdjustingtheHeightofCut
Adjusttheheightofcutfrom25to140mm(1to5-1/2
inches)in6mm(1/4inch)incrementsbymovingthe
clevispinintodifferentholelocations.
1.Withtheenginerunning,pushthedeck-lift
switchrearwarduntilthemowerdeckisfully
raised,andreleasetheswitchimmediately.
2.Rotatetheheight-of-cutpinuntiltherollpin
initlinesupwiththeslotsintheholesinthe
height-of-cutbracketandremoveit(Figure25).
3.Inserttheheight-of-cutpinintothehole
correspondingtothedesiredcuttingheight
(Figure25).
Refertothedecalonthesideofthedeck-lift
platefortheheightsofcut(Figure25).
4.Usingthedeck-liftswitch,movethedeckheight
outofthetransportposition(or5-1/2inches(140
mm)cuttingheight)anddowntotheselected
height.
g227689
Figure25
1.Height-of-cutbracket2.Height-of-cutpin
AdjustingtheAnti-Scalp
Rollers
Formaximumdeckotation,installtherollers1hole
positionlower.Rollersshouldmaintaina6mm(1/4
inch)clearancetotheground.Donotadjustthe
rollerstosupportthedeck.
1.Parkthemachineonalevelsurface.
2.Disengagetheblade-controlswitch(PTO),move
themotion-controlleverstotheNEUTRAL-LOCK
position,andengagetheparkingbrake.
3.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
4.Adjusttheanti-scalprollersasshowninFigure
26,Figure27,andFigure28.
g227785
Figure26
1.Flangenut3.Bushing
2.Anti-scalproller4.Bolt
28