FORM NO. 3318-279 LAWN & GARDEN TRACTOR MODEL NO, & UP S MODEL NO. & UP ET-UP MODEL NO. & UP MODEL NO. & UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. USE Front Wheel Fiat Washer-large OD Shim Washer Dust Cover Cotter Pin Hub Cap {optional on some models) Rear Wheel Wheel Bolt Hub Cap (optional on some models) Install front wheels. Install rear wheels.
Set-Up Instructions Install Front Wheels Note: If wheels are already installed, refer to Check Tire Pressure (below). 1. Slide wheel onto axle with valve stem in. (Fig. 1), 2. Wheel end play should be (0-.4 mm). Use shim washers (as required) and large OD flat washer for spacing on the axle. Insert cotter pin through the axis and bend the ends of the pin open (Fig. 1). 3, Push the dust cover (Fig. 1) onto the end of the axle 50 it snaps over washer. Figure 1 1. Wheel 4. Cotter pin 2. Shim washers (as 5.
Install Steering Wheel Position front wheels straight ahead. Line up center spoke toward the seat and position the steering wheel onto shaft spline (Fig. 3). Secure steering wheel with lock washer and nut (Fig. 3). Torque steering wheel nut to 50 phi-Ibs (37 N'm). Snap logo cover into place (Fig. 3). 2307 Figure 3 Center spoke 4 Nut Shalt spine 5. Logo cover Lock washer Set-Up Instructions Install Seat 1. L Note: If the seat is already installed, proceed 1o Activate The Battery, page 4.
Set-Up Instructions Activate the Battery Bulk electrolyte with 1.260 specific gravity must be purchased from a local battery supply outlet. 1. Remove the battery from the tractor: refer to Operator’s Manual, Removing the Battery.
FIZZY TN POTENTIAL HAZARD * Charging battery produces gasses. ‘WHAT CAN HAPPEN * Battery gasses can explode. HOW TO AVOID THE HAZARD + Keep cigarettes, sparks and flames away from battery. 4, When the battery is fully charged, disconnect the charger from the electrical outlet then from the negative and positive battery posts {(Fig. 6). 5. Slowly pour electrolyte into each cell until the level is once again up to the “UPPER” line on the battery case (Fig. 5) and install covers. 6.