Operator's Manual

AdjustingtheHeightofCut
Thecuttingheightofthemowerdeckcanbeadjusted
from2.54cmto14cm(1to5-1/2inches)in6.4mm
(1/4inch)increments.
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitch,andengagetheparking
brake.
2.Pressthetopofdeck-liftswitchtoraisethe
centerdeckandwingdecks.
3.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
4.Adjustthecenterdeckbyperformingthe
followingprocedure:
A.Removetheheight-of-cutpinfromthe
deck-liftplateontherightsideofthecenter
deck.
B.Inserttheheight-of-cutpinintothehole
correspondingtothedesiredcuttingheight.
Seethedecalonthesideofthedeck-lift
plateforthecuttingheights.
5.Adjustthesidewingdecksbyperformingthe
followingprocedure:
A.Ensurethatthewingdecksarelockedin
place.
B.Unlockthecamlockslocatedonthe
height-of-cutchannelonthewingdeck
(Figure28).
g239055
Figure28
1.Camlock
3.Lynchpin
2.Height-of-cutpin
C.Removethelynchpinfromtheheight-of-cut
pinonboththefrontandrearchannels.
D.Movethewingdecktotheappropriate
heightandinstalltheheight-of-cutpinsand
lynchpins(Figure28).
E.Lockthecamlock.
F.Repeatfortheotherwingdeck.
6.Ifyoudesireadditionalheight-of-cutrange,
adjustthefrontandreargaugewheelsonthe
wingdeckasfollows:
A.Removethemountinghardwarefromthe
gaugewheel.
B.Adjustthefrontandreargaugewheels
totheappropriateholelocation(seethe
chartbelowandFigure29)andinstallthe
mountinghardware.
HoleLocation
Height-of-CutRange
Tophole(-1onthedecal)25to89mm(1to3-1/2inches)
Middlehole(0onthedecal)51to114mm(2to4-1/2
inches)
Bottomhole(+1onthedecal)76to140mm(3to5-1/2
inches)
g212253
Figure29
Height-of-cutrange
1.Tophole(-1onthedecal)
2.Middlehole(0onthedecal)
3.Bottomhole(+1onthedecal)
C.Repeatfortheotherwingdeck.
33