Operator's Manual

Note:Inmostconditions,youshouldadjustthe
reartipsontheblades6.4mm(1/4inch)higher
thanthefront.
3.Measureuntilall4sidesareatthecorrect
height.
4.Tightenallthenutsonthedeck-liftarm
assemblies.
5.Ifthe4deckadjusters(Figure80)donothave
enoughadjustmenttoachievetheaccurate
heightofcutwiththedesiredrake,youcan
utilizethesingle-pointadjustmenttogainmore
adjustment.
6.Toadjustthesingle-pointsystem,rstloosen
thefrontandrearheight-of-cutplatemounting
bolts(Figure81).
Fine-tunetherearadjustersasrequired.You
canadjustthesingle-pointadjustmenttogain
moreadjustment.
g239211
Figure80
1.Adjusterlink3.Adjuster
2.Jamnut
7.Ifthedeckistoolow,tightenthesingle-point
adjustmentboltbyrotatingitclockwise(Figure
81).
Ifthedeckistoohigh,loosenthesingle-point
adjustmentboltbyrotatingitcounterclockwise.
Loosenthefrontandrearheight-of-cutplate
mountingbolts.Fine-tunetherearadjusters
asrequired.Youcanadjustthesingle-point
adjustmenttogainmoreadjustment.
Note:Loosenortightenthesingle-point
adjustmentboltenoughtomovethe
height-of-cutplatemountingboltsatleast1/3
thelengthoftheavailabletravelintheirslots.
Thiswillattainsomeupanddownadjustment
oneachofthe4decklinks.
g232012
Figure81
1.Single-pointheightadjustmentbolt
2.Frontheight-of-cutplatemountingbolt
3.Rearheight-of-cutplatemountingbolt
8.Torquethefrontandrearheight-of-cutplate
mountingboltsto37to45N∙m(27to33ft-lb).
AdjustingtheWingDecks
1.Measurefromthelevelsurfacetothefronttipof
theleftwingdeckblade.
Note:Themeasurementshouldread102mm
(4inches).
2.Measurefromthelevelsurfacetothefronttipof
therightwingdeckblade.
Note:Themeasurementshouldread102mm
(4inches).
Note:Aswiththecenterdeck,inmost
conditions,youshouldadjustthereartipson
thewingblades6.4mm(1/4inch)higherthan
thefront.
3.Theleftandrightwingdeckshavebladeheight
adjustmentswithfrontandrearadjustment
points.T oadjustthewing-bladeheight,rst
loosenthefrontandrearheight-of-cuthanger
mountingnuts.Thereare4locations(2oneach
sideofthechannel)asshowninFigure82.
69