Operator's Manual

20
To slow down, release the pressure on the traction control
pedal.
Important To avoid transmission damage, always
release the parking brake before moving the traction
control pedal.
1
2
1210
Figure 12
1. Forward 2. Backward
Stopping the Machine
To stop the machine, release the traction control pedal,
disengage the power take off (PTO), and turn the ignition
key to off. Also set the parking brake if you leave the
machine unattended; refer to Setting the Parking Brake,
page 15. Remember to remove the key from the ignition
switch.
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition and KeyChoice keys
and set the parking brake when leaving the
machine unattended, even if just for a few
minutes.
Caution
Using the Attachment Power
Lift
The attachment power lift (Fig. 13) is used to raise and
lower attachments.
Raising Attachments
1. Turn key to the on or run position (Fig. 13).
2. Push the lift switch in the up direction to raise the
attachment lift (Fig. 13). This will lift and hold the
attachment in the up, or raised position.
Lowering Attachments
1. Turn key to the on or run position (Fig. 13).
2. Push the lift switch in the down direction to lower the
attachment lift (Fig. 13). This will lower the
attachment lift.
m–6513
2
3
1
Figure 13
1. Key
2. Lift switch —up
3. Lift switch —down
Operating the Attachment Lift
Lever
The attachment lift lever (Fig. 14) is used to raise and
lower various attachments.
Raising an Attachment
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull attachment lift lever rearward until latch locks. In
this position the lift will hold the attachment in the up,
or raised position.
Lowering an Attachment
1. Depress the clutch and brake pedals to stop the
machine.
2. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release the
latch. Move lift lever forward to lower attachment.