Service Manual

16
310-3000 IHT
BYPASS ASSEMBLY
Refer to Figure 8.
DISASSEMBLY
1. Remove self tapping screw (138), and exten-
sion spring (136).
2. Remove snap ring (42), and bypass arm (41).
3. Remove bypass lip seal (40).
INSPECTION
1. Inspect spring pin (137) for damage.
ASSEMBLY
1. If necessary, install new spring pin (137).
2. Install bypass lip seal (40).
3. Install bypass arm (41), and snap ring (42).
4. Install self tapping screw (138), and exten-
sion spring (136).
REF. Part Name
1 Main Housing
40 Lip Seal
41 Bypass Arm
42 Retaining Ring
136 Spring
137 Spring Pin
138 Screw
Figure 8. Bypass Assembly
42
41
40
137
138
136
1