Service Manual

310-3000 IHT 21
INPUT SHAFT ASSEMBLY
Refer to Figure 12.
DISASSEMBLY
1. Drain the oil from the transaxle.
2. Remove snap ring (7), input shaft lip seal (5),
and spacer (4).
3. Remove input shaft assembly (12), (8), (6).
4. Remove washer (13) from cavity.
INSPECTION
1. Inspect bearing (8) for damage and, if nec-
essary replace bearing, remove wire retain-
ing ring (6) and bearing (8) from input shaft
(12).
ASSEMBLY
1. Carefully install washer (13) onto top of spring
in cavity.
2. Press bearing (8) onto input shaft (12) and
secure by installing wire retaining ring (6).
3. Install input shaft assembly (12), spacer (4),
and lip seal (5) into input bearing bore of main
housing (1).
4. Secure input shaft assembly (12) by install-
ing retaining ring (7).
Figure 12. Input Shaft Assembly
7
5
4
6
8
12
1
7
5
4
6
8
12
REF. Part Name
1 Main Housing
4 Spacer
5 Lip Seal
6 Wire Retaining Ring
7 Snap Ring
8 Ball Bearing
12 Input Shaft
13
Block Thrust Washer