Service Manual

310-3000 IHT 29
Figure 18. Directional Control Assembly
DIRECTIONAL CONTROL
ASSEMBLY
Refer to Figure 18.
NOTE: The Motor/Center Section/Pump
Assembly must be disassembled before
this procedure can be completed.
DISASSEMBLY
1. Remove swashplate assembly (10). Disas-
semble swashplate assembly by removing
thrust bearing (11) from swashplate (10). The
thick race of thrust bearing must face pistons.
2. Remove slot guide (30).
INSPECTION
1. Visually inspect (in place) the two cradle bear-
ings (9), which are staked in upper housing.
Do not remove the Cradle Bearings (9) from
housing (1).
ASSEMBLY
1. Install slot guide (30).
2. Assemble swashplate assembly (10) by in-
stalling thrust bearing (11) into swashplate
(10).
Note: Assemble thrust bearing with thick
race facing pistons.
3. Install swashplate assembly (10) into main
housing (1). The swashplate (10) will couple
with slot guide (30).
NOTE: When installing swashplate as-
sembly (10), use flat head screwdriver to
hold slot guide (30) in place.
.
1
9
10
30
11
REF. Part Name
1 Main Housing
9 Cradle Bearing
10 Variable Swashplate
11 Thrust Bearing
30 Slot Guide
11
9
30
(not removable)