Service Manual

4
310-3000 IHT
SECTION 2. SAFETY
PERSONAL SAFETY
Certain safety precautions must be observed
while servicing or repairing the 310-3000 IHT.
This section addresses some of these precau-
tions but must not be considered an all-inclusive
source on safety information. This section is to
be used in conjunction with all other safety mate-
rial which may apply, such as:
Other manuals pertaining to this machine
Local and shop safety rules and codes
Governmental safety laws and regulations
Be sure that you know and understand the
equipment and the hazards associated with it.
Do not place speed above safety.
Notify your supervisor whenever you feel there is
any hazard involving the equipment or the per-
formance of your job.
Never allow untrained or unauthorized person-
nel to service or repair the equipment.
WARNING
POTENTIAL FOR SERIOUS INJURY
Inattention to proper safety, operation, or
maintenance procedures could result in
personal injury, or damage to the equip-
ment. Before servicing or repairing the
310-3000 IHT, fully read and understand
the safety precautions described in this
section.
Wear appropriate clothing. Loose or
hangingclothing or jewelry can be hazardous.
Use the appropriate safety equipment, such as
eye and hearing protection, and safety-toe and
slip-proof shoes.
Never use compressed air to clean debris from
yourself or your clothing.
TOOL SAFETY
Use the proper tools and equipment for the task.
Inspect each tool before use and replace any tool
that may be damaged or defective.
WORK AREA SAFETY
Keep the work area neat and orderly. Be sure it
is well lit, that extra tools are put away, trash and
refuse are in the proper containers, and dirt or
debris have been removed from the working ar-
eas of the machine.
The floor should be clean and dry, and all exten-
sion cords or similar trip hazards should be re-
moved.
SERVICING SAFETY
Certain procedures may require the vehicle to
be disabled in order to prevent possible injury
to the servicing technician and/or bystanders.
The loss of hydrostatic drive line power may re-
sult in the loss of hydrostatic braking capability.
Proper brake maintenance is very important
should this condition develop.
Some cleaning solvents are flammable. Use only
approved cleaning materials: do not use explo-
sive or flammable liquids to clean the equipment.
To avoid possible fire do not use cleaning sol-
vents in an area where a source of ignition may
be present
Discard used cleaning material in the appropri-
ate containers.
This symbol points out important
safety instructions which, if not followed, could
endanger the personal safety and/or property
of yourself and others. Read and follow all in-
structions in this manual before attempting
maintenance on your transaxle. When you see
this symbol - HEED ITS WARNING.