Addendum

1
 2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
Original Instructions (GB)
417XT and 419XT
Wheel Horse

Garden Tractor
Model No. 72211—240000001 and Up
Model No. 72212—240000001 and Up
Form No. 3351–401
Addendum
Important The following instructions are updates for
the Setup instructions in the tractor Operator’s Manual.
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
Description Qty. Use
Steering Wheel
Lock Washer, 1/2 inch
Nut, 1/2 inch
Logo Cover
1
1
1
1
Install the steering wheel
Seat
Spacer, small inside diameter
Spacer, large inside diameter
Shoulder Bolt
Knob
Flat Washer, 11/32 inch
1
2
2
2
2
2
Install the seat
Installing the Steering Wheel
1. Position the front wheels straight ahead.
2. Remove the logo cover by releasing the 3 latches from
the back side with a screwdriver.
3. Line up the center spoke toward the seat and position
the steering wheel onto the shaft spline (Fig. 1).
4. Secure the steering wheel with a lockwasher (1/2 inch)
and nut (1/2 inch) (Fig. 1).
5. Torque the steering wheel nut to 50 ft-lb (37 N
.
m).
6. Snap the logo cover into place (Fig. 1).
2307
2
3
1
4
5
Figure 1
1. Center spoke
2. Shaft spline
3. Lock washer, 1/2 inch
4. Nut, 1/2 inch
5. Logo cover
Installing the Seat
1. Install the large inside diameter spacer and the 2
shoulder bolts into the rear holes of the seat (Fig. 2).