Service Manual

MOWER DECKS

6-34 Toro Z Master G3 3000/5000/6000 Series Service Manual

A. Brake mounting bolt

Fig. 479 g. 72 G010870

7. Using needle nose pliers, or by hand, take hold of

the tab and remove the shim (Fig. 480).

Note: Do not discard the shim until proper clutch

function has been conrmed.

Fig. 480 g. 73 G010871

5. Measure the gap between the rotor and armature. If

the gap is greater than 0.04” (1mm), proceed.

6. Loosen both brake mounting-bolts one-half to one

full turn (Fig. 479).

Note: Do not remove the brake pole from the eld

shell/armature. The brake pole has worn to

match the armature and needs to continue

to match after the shim is removed to ensure

proper brake torque.

8. Using a pneumatic line, blow out any debris from

under the brake pole and around the brake spacers.

9. Re-torque each bolt (M6 x 1) to 10 ± 0.5 ft-lbs. (13 ±

0.7 Nm).