FORM NO. 3318-267 ( GARDEN TRACTOR TOR, SET P 300 SERIES INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY.
Set-Up Instructions DESCRIPTION QTy. USE Bolt ~ x 3/4” Attaching the battery cables Hex Nut Hairpin Cotter 1 3 Attaching accessory to lift bar Flat Washer 1/2” 1 Spare Key 1 Use in ignition switch Operator’s Manual 1 Read before operating tractor Set Up instructions 1 Read before smelting up tractor Maintenance Checklist 1 Attach to underside of hood Riding Mower Safety Video 1 View before operating tractor Installing the Front Wheels 1.
Set-Up Instructions Installing the Rear Wheels 1. Remove the wheel bolts holding the rear 1. shipping brackets to the rear hubs. 2. Install the wheels onto the hub with the valve 2. stems facing inward (Fig. 2). 3. Torque the wheel bolts to 75-80 phi-lb 3. (105-112 Nome. 4. Install the logo hubcaps (optional on some models). w278 Figure 2 1. Hub 3. Wheel Brit (5) 2. Rear Wheel 4. Logo Hubcap {optional) Checking the Tire Pressure Check the front and rear tire pressure.
Set-Up Instructions Activating the Battery DANGER POTENTIAL HAZARD = Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns. WHAT CAN HAPPEN * If you carelessly drink electrolyte you cold die or if it gets onto your skin you will be burned. HOW TO AVOID THE HAZARD ® Do not drink electrolyte and avid contact with skin, eyes or clothing. Wear safety glasses to shield your eyes and rubber gloves to protect your hands.
Set-Up Instructions 5. 4\ WARNING POTENTIAL HAZARD # Charging battery produces gasses. 6. WHAT CAN HAPPEN * Battery gasses can explode, HOW TO AVOID THE HAZARD + Keep cigarettes, sparks and flames away from battery. 3. Leave the filler caps off and connect a 3-4 amp battery charger to the battery posts (Fig. 5). Charge the battery at a rate of 4 amperes or less for 4 hours (12 violist. 4.
Set-Up Instructions Install the shoulder bolts and Sarge LD. spacers Position the seat onto the seat base by inserting openings in the seat base slots. Make sure the large LD. spacers ave positioned between the seat Locate the small LD, spacers between the seat and seat base, then thread the hand knobs and (Fig. 6). Adjust the seat and tighten the knobs.
Checking the Wiring and Fasteners Inspect the tractor for any loose electrical connections and secure as required. Check the wire routing to make sure no moving parts interfere with the wires to cause a short. Check all fasteners to make sure they're tight, Attaching the Maintenance Chart Attach the MAINTENANCE CHART to the underside of the hood. Test Driving the Tractor 1. Check the oil level in the crankcase. Refer to the Operator’s Manual for oil type, viscosity and crankcase capacity.