FORM NO. 3319-268 GARDEN TRACTOR ) SET UP 400 SERIES INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION Front Whee! Assemblies Shim Washer — 015" thick Shim Washer .
Set-Up instructions DESCRIPTION arty. USE Spare Key 1 Use in ignition switch Operator’s Manual 1 Attach to tractor Set Up Instructions 1 Setting up tractor Maintenance Checklist 1 Attach to underside of hood Riding Mower Safety Video 1 Attach to tractor Installing the Front Wheels 1. Install the front wheels onto the spindles with the valve stems facing inward (Fig 1). 2. Install one O.D. hubcap washer onto each spindle, then insert the cotter pin into the hole in the spindle (Fig.
Set-Up Instructions Installing the Rear Wheels Installing the Steering Wheel 1. Remove the wheel bolts holding the rear 1. Position the front wheels so they point straight shipping brackets to the rear hubs, ahead. 2. Install the wheels onto the hub with the valve 2. Install the steering tube onto the steering wheel stems facing inward (Fig. 2). shaft with the beveled end down (Fig 3). 3. Torque the wheel bolts to 75-80 phi-1b 3. Install one .120" thick flat washer and the bowed (105-112 Eminem.
Set-Up Instructions Activating the Battery & pang POTENTIAL HAZARD e Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns, WHAT CAN HAPPEN # If you carelessly drink electrolyte you could die or if it gets onto your skin you will be burned. HOW TO AVOID THE HAZARD + Do not drink electrolyte and avoid contact with skin, eyes or clothing, Wear safety glasses to shield your eyes and rubber gloves to protect your hands.
3. FIQU7N TV POTENTIAL HAZARD * Charging battery produces gasses. WHAT CAN HAPPEN * Battery gasses can explode, HOW TO AVOID THE HAZARD + Keep cigarettes, sparks and flames away from battery. Leave the filler caps off and connect a 3-4 amp battery charger to the battery posts (Fig. 5). Charge the battery at a rat of 4 amperes or less for 4 hours (12 volts}). When the battery is fully charged, unplug the charger from the electrical outlet, then disconnect the charger leads from the battery posts (Fig. 5). 1.
Set-Up Instructions Inst ailing the Seat 1. Remove the plastic thread protector caps from the threaded studs on the bottom of the scat. 2. Install the seat onto the leaf springs, making sure the four seat studs fit through the matching holes in the leaf springs (Fig. 6). 3. Make sure the scat switch wire is routed correctly through the center opening in the seat base, then fasten the seat to the leaf springs with the four 5/16” lockouts (Fig 6). 4.
Checking the Wiring and Fasteners Inspect the tractor for any loose electrical connections and secure as required. Check the wire routing to make sure no moving parts interfere with the wires to cause a short. Check all fasteners to make sure they’re tight. Attaching the Maintenance Chart Attach the MAINTENANCE CHART to the underside of the hood. Test Driving the Tractor L Check the oil level in the crankcase. Refer to the Operator’s Manual for oil type, viscosity and crankcase capacity.