Service Manual

5003 - 5010 DIFFERENTIAL
OVERHAUL
For removal of differential assembly, see Trans-
mission Disassembly Section.
Disassembly:
1. Drive the roll pins from the end of the differ-
ential pins, remove the pins (early models used
roll pins at each end of
the differential pins) and
remove the spider gears. See Figure
1.
FIGURE 1
2. Drive the roll pins out of the axles and pull the
axles from the axle gears. See Figure
2.
FIGURE 2
3. lift the axle gears out of the case. Remove the
Woodruff keys from the axles.
Cleaning, Inspection, Parts Replacement
Thoroughly clean all parts and inspect for damage
and wear.
Use a suitable arbor when replacing bush-
ings.
If replacement of the differential case or gear is
required, refer to Service Note 5, Page 12.
Figure 3 shows a breakdown of the entire differ-
ential assembly.