Service Manual

9. Lift out the axle and differential assembly. Figure
4. Note: If only the differential is to be over-
hauled the transmission need not be further
dis-
assembled. See Differential Overhaul Section.
10. Shift the 2nd and high shift fork assembly up
into the 2nd speed position. See Figure
4.
(NEUTRAL POSITION)
LOW & REVERSE SHIFT FORK
FIGURE 4
The following steps 11 through 17 apply to all
unidrive models except 5058 and 5059. For models
5058 and 5059 follow steps 1A through 7A.
FIGURE
6
11. Remove the splined pinion shaft and gear. At
the same time the cluster gear assembly may be
removed. See Figure
5.
FIGURE 7
14. Place the shift forks in neutral and remove first
the low and reverse shift rail and fork assembly,
then the 2nd and
high shift rail and fork assem-
bly, being careful not to lose the two stop balls,
spring and stop pin
as they are released. Fig-
ure 8.
12.
13.
FIGURE 5
Remove the brake shaft gear assembly and the
reverse idler gear. See Figure
6.
Remove the 2nd and high sliding gear and the
low and reverse sliding gear, as shown in Figure
7. FIGURE 8
- 17 -