Service Manual

5060 6-SPEED TRANSMISSION 6. Remove the brake drum retaining ring and
remove the brake drum using a suitable puller
as required.
Disassembly:
1.
2.
Remove axle hubs and input pulley.
7. Remove paint and burrs from both axle shafts,
brake shaft and the inut shaft.
I
Place the transmission assembly in a vise or 8. Remove the six (6) 3/8” x 16 bolts and nuts that
suitable holding fixture, as shown in Figure
1 retain the right hand and left hand cases.
(shown with levers, brake band, brake drum,
hubs, and input pulley removed).
9. Remove the left hand case leaving all gears
intact, as shown in Figure 2.
FIGURE 1
10. lift out the axle and differential assembly. Note:
If only the differential is to be overhauled, the
transmission section need not be further
dis-
assembled. Refer to Differential Overhaul Section.
11. Shift the 2nd and high shift fork assembly up
into the 2nd speed position.
See Figure 3.
3. Place the shift lever in neutral and pull the shift
lever rubber boot from the transmission boss.
loosen the shift lever retaining lock nut and set
screw and remove the
shift lever.
4. Remove the roll pin and remove the high-low
range lever.
and remove the brake band.
5. Remove the two (2) brake band retaining bolts
FIGURE 3
12. Remove the cluster gear assembly, the brake
shaft assembly and the reverse idler gear and
shaft.
13. Remove the splined pinion gear from the input
shaft.
14. With a screw driver or other suitable tool remove
the plug from the detent passage, as shown in
Figure
4.
FIGURE 2 FIGURE 4