Service Manual

10. Install the 2nd and high shift rail and fork as-
sembly (the one with the unequally spaced detent
grooves) together with the 2nd and high sliding
gear (the smaller of the two sliding gears).
The
sliding gear tits down over the input shaft with
the
shift fork groove up.
11. Install one of the stop balls, stop spring and
stop pin into the detent passage.
FIGURE 14
12. Install the 2nd stop ball and using a punch,
push the ball in against
the spring. Move the
installed shift rail into the neutral position and
continue to push on the punch (Figure
14) until
the ball
is flush with the shift rail bore. At the
same time insert the low and reverse shift rail
and fork assembly together with the low and
reverse sliding gear, (Figure
15) removing the
punch as the shift rail passes the ball. See
de-
tent drawing Figure 17. Note: The low and re-
verse gear fits down over the input shaft with
the shift fork groove down.
FIGURE 15
13.
Install the splined pinion gear.
14. Shift the 2nd and high shift rail and fork assem-
bly into 2nd
speed position.
15. Install the reverse idler gear shaft and gear as-
sembly making sure
the shoulder of the gear
goes down. Figure
16.
FIGURE 16
FIGURE 17
16.
Install the brake shaft gear.
- 31 -