Service Manual

The matching roll pin holes in the left hand 5. Remove the end caps and thrust washers from
end cap are also located next to the bolt holes, each axle.
but in the right hand end cap they are between
bolt holes as shown in Figure
6. 6. The axle gears may be removed after removing
the retaining snap rings.
FIGURE
5 shows the differential parts in relation
to each other. Note, that
the right hand end cap
and axle
is noticeably longer than the left hand
end cap and axle.
LIMITED SLIP DIFFERENTIAL
Assembly:
1. Install the axle gears on the axles and install
the retaining snap rings.
FIGURE
3
FIGURE 4
2. Place the axle gear to end cap thrust washers
on the axles next to the axle gears and install
the respective end caps on the axles. Note that
the right hand axle and the hub
of the right
hand end cap
is longer than the left hand axle
and left hand end cap.
3. Using the left hand case as a workstand, place
the right hand (long) axle and right hand end
cap (long) assembly in the axle housing. Figure
6.
!
HOLE
PIN HOLE
FIGURE 6
4. Align the roll pins with their respective holes
and seat one of the bodies in place on the end
cap.
Refer to Figure 7.
5. Install the ten (10) differential pinions in their
respective bores. Refer to Figure
7.
6. Hold the cylindrical spring with suitable pliers,
as shown in Figure
7 and compress the spring,
inserting
it in the center of the pinions, seating
it down against the axle gear.
7. Position the differential ring gear over the body.
After careful alignment press the gear down over
the body until
it seats on the end cap. Figure 8.
FIGURE 5
- 33 -