Service Manual

tent drawing Figure 17. Note: The low and re-
verse gear fits down over the input shaft with
the shift fork groove down.
FIGURE 15
13.
Install the splined pinion gear.
14. Shift the 2nd and high shift rail and fork assem-
bly into 2nd speed position.
sembly (and the thrust washer
if used).
15. Install the large pinion and reduction gear as-
16. Install the reverse idler gear shaft and gear as-
sembly making sure the shoulder of the gear
goes down. Figure
16.
FIGURE 16
17.
Install the cluster gear and brake shaft assem-
bly. See Figure
18.
18. Install the differential and axle assembly with
the retaining bolt nuts
up toward the left hand
case. Figure
19.
19. Recheck for proper assembly, a free neutral and
proper operation in all gears in both ranges.
Place the shift forks in neutral position.
20. Install a new case gasket holding it in place
with gasket sealer and install the left hand case.
FIGURE 17
!
CLUSTER GEAR & BRAKE SHAFT
FIGURE 18
21.
Install the six (6) 3/8'' x 16 bolts and nuts and
tighten all bolts evenly to avoid distortion.
22. Install the shift lever assembly and retain with
the set screw and lock nut. Install gear shift
lever rubber boot.
23. Install the high-low range selector lever and
24. Recheck for a free neutral and proper operation
retain with
the 3/16” roll pin.
in all gears and ranges.