Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 73449



The T

oro Company – 1998

Printed in USA

FORM NO. 3322–108

SET UP

INSTRUCTIONS

CLASSIC GARDEN TRACTOR

300 SERIES

S/N 9900001 & Up

Loose

Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Hitch Pin

Hairpin Cotter – 1-7/8”

Flat W

asher – 1/2 x 1”

Installing the hitch pin

Bolt – 1/4–20 x 3/4”

Hex Nut – 1/4–20

Attaching the battery cables

Hairpin Cotter – 1-7/8”

Flat W

asher – 1/2 x 1”

Attaching accessory to lift bar

Operator’

s Manual

Set Up Instructions

Riding Mower Safety V

ideo

Read before operating tractor

Read before setting up tractor

iew before operating tractor

Summary of content (4 pages)

PAGE 1
FORM NO. 3322–108 CLASSIC GARDEN TRACTOR 300 SERIES S/N 9900001 & Up SET UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY.
PAGE 2
Set-Up Instructions Checking the Tire Pressure 2. Check the front and rear tire pressure. The correct front and rear tire pressure is 12 psi (83 kPa). Remove the filler caps from the battery. Slowly pour electrolyte into each cell until the electrolyte level is up to the lower part of the tube (Fig. 1). Use an electrolyte with a specific gravity of 1.265. 1 Activating the Battery 2 POTENTIAL HAZARD • Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns.
PAGE 3
Set-Up Instructions 4. Installing the Drawbar Hitch Pin When the battery is fully charged, unplug the charger from the electrical outlet, then disconnect the charger leads from the battery posts (Fig. 2). Insert the drawbar hitch pin into the drawbar hitch and secure it with a 1/2 x 1” flat washer and 1-7/8” hairpin cotter (Fig. 3). 4 2 3 1 1 2 4 1254 Figure 2 1. Positive Battery Post 2. Negative Battery Post 5. 6. 3. Red (+) Charger Lead 4. Black (–) Charger Lead 3 m–3396 Figure 3 1.
PAGE 4
Set-Up Instructions Checking the Wiring and Fasteners • • 5. Inspect the tractor for any loose electrical connections and secure as required. Check the wire routing to make sure no moving parts interfere with the wires to cause a short. Check all fasteners to make sure they are tight. Test Driving the Tractor 1. Check the oil level in the crankcase. Refer to the Operator’s Manual for oil type, viscosity and crankcase capacity. Note: 2. 3. 4.