Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 73547



The T

oro Company – 1999

Printed in USA

FORM NO. 3321–967

SET UP

INSTRUCTIONS

MODEL NO. 73547–9900001 & UP

520Lxi GARDEN TRACTOR

Loose

Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Seat Assembly

Shoulder Bolt – 5/16”

Locknut – 5/16”

Installing the seat

Steering Wheel

Boot W

asher

Nut

Lock W

asher

rim Cover

Installing the steering wheel

Bolt – 1/4”-20 x .88” Long

asher– 1/4”

Hex Nut – 1/4”-20

Attaching the battery cables

Hitch Pin

Hairpin Cotter

Flat W

asher – .50” I.D.

Installing the drawbar hitch pin

Key 2

Use in ignition and “Key Choice” switches

Operator’

s Manual

Engine Operator

’

s Manual

Read before operating the tractor

Riding Mower Safety V

ideo 1

Attach to the tractor

“Thank Y

ou” Card

1 Mail

Summary of content (8 pages)

PAGE 1
FORM NO. 3321–967 520Lxi GARDEN TRACTOR MODEL NO. 73547–9900001 & UP SET UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Seat Assembly 1 Shoulder Bolt – 5/16” 2 Locknut – 5/16” 2 Steering Wheel 1 Boot Washer 1 Nut 1 Lock Washer 1 Trim Cover 1 Bolt – 1/4”-20 x .88” Long 2 Washer– 1/4” 2 Hex Nut – 1/4”-20 2 Hitch Pin 1 Hairpin Cotter 1 Flat Washer – .50” I.D.
PAGE 2
Set-Up Instructions Installing the Seat 3. 1. Mount the seat to the seat base using two 5/16” shoulder bolts and lock nuts (Fig. 1). 2. Insert the seat switch wire through the center opening in the seat base (Fig 1). 3. Push the seat switch wire connector into the wire harness connector. Install the steering wheel onto the shaft, carefully aligning the splines (Fig. 2). Note: There is no fixed straight ahead position on power steering models. 4.
PAGE 3
Set-Up Instructions Check to Insure that the Steering Linkage is Centered 1. With the tractor on a level surface, turn the steering wheel fully to the left and check the clearance of the left hand spindle stop to the stop on the front axle. There should be a slight clearance between the stops (Fig. 3). Checking Tire Pressure Check front and rear tire pressure. The correct front and rear tire pressure is 20 psi (138 kPa).
PAGE 4
Set-Up Instructions 1 4 2 3 1 2 3 1262 Figure 4 1. Filler caps 2. Electrolyte 3. Lower part of tube 1254 Figure 5 1. Positive battery post 2. Negative battery post POTENTIAL HAZARD • Charging battery produces gasses. 5. Slowly pour electrolyte into each cell until the level is once again up to “UPPER” line on the battery case (Fig. 4), then install the filler caps. 6.
PAGE 5
Set-Up Instructions 3. Repeat these procedures (1 and 2) 5 times. Test Driving the Tractor 1 2 1. Check the oil level in the crankcase (refer to Engine Oil in your tractor Operator’s Manual for oil type, viscosity and crankcase capacity). 2. Check the oil level in the transaxle (refer to Transaxle Fluid in your tractor Operator’s Manual for oil type, viscosity and capacity). 3. Check the coolant level in the coolant recovery tank. 4.
PAGE 6
PAGE 7
PAGE 8